Ultrasonic Plastic Welding Surface Scratch Solution

Ultrasonic welding surface scratch, is the long-term use of ultrasonic welding machine often encountered problems, encountered plastic ultrasonic welding surface scratch how to do? Taiwan Minghe ultrasonic welding machine technicians tell us:

1, encountered ultrasonic welding machine surface scratch if it is ultrasonic welding head work is not good, then try to avoid that easy to be welding position.

2, if the fixed position of welding injury is not in contact with the ultrasonic welding head. It is suggested to find Taiwan Minghe to redo a good ultrasonic welding head.

Spring arrived, the south is affected by the weather, air moisture is too much, will cause the phenomenon of moisture, wet floor, wet machine, also caused by the damp electronic components in the machine performance change or conductive, so that the machine can not be used normally, failure. In fact, these are minor problems, only regular maintenance, clean and dry, it is ok, there is no problem. Because of the reasons for the return of the tide is often the fault: ultrasonic welding machine no sound, then ultrasonic welding machine no sound to do? How do you solve it?

In fact, the solution is very simple: if there is no sound wave as long as the circuit board can be dried can be used normally. Of course, if the damage is serious, it will have to change another crystal plate. Under normal circumstances, it can be blown dry by electric fan.

In the use of ultrasonic welding machine ultrasonic plastic welding machine maintenance method is actually very important, if a machine is well maintained, the frequency of failure will be much less.